Joe Clay reviews the work of Chris and Ed while Foundation Board Chairman Glen Macfadden observes the work in progress. We worked on assembling some of the parts that were cut out on the CNC. The frames and bulkheads needed the addition of doublers to add strength to the sides. Also the stringers that were scarfed needed to be glued at the scarf joints. The adhesive of choice was epoxy, a thermoset adhesive which is resistant to water and not affected by heat. Epoxy is a mixture of hardener and resin. It must be thoroughly mixed, and since it cures rapidly it must be applied quickly. Watch the slide show below for the action. We started work on the keel and planks for the sides of the boat. Also we began to work on two other boats that need deck or hull repair.
No comments:
Post a Comment